GROUTING MIXTURE CERESIT CE 33 ANTHRACITE, 13

DESCRIPTION

CERESIT® CE 33 is used for gluing tiles, it must be sufficiently hard and dry. The joints are first cleaned and dusted,
Then moisten them. For matte, absorbent tiles and those whose surfaces are easily scratched, it is recommended to do a test first.

ANNEX

For grouting flooring and wall coverings made of ceramic tiles, porcelain tiles, glass and porcelain mosaics
indoors and outdoors.

PREPARATION OF THE BASE FOR LAYING CERESIT CE 33
The surface and thin-layer mortar, dispersion adhesive or thick-layer mortar must be sufficiently hard and dry.
Before applying CERESIT CE 33, the scraped joints must first be wetted.
In the case of tiled surfaces with a porous or non-scratch-resistant surface, test the suitability of CE 33 for grouting.

PREPARATION OF THE BASE FOR LAYING CERESIT CE 33

The surface and thin-layer mortar, dispersion adhesive or thick-layer mortar must be sufficiently hard and dry.
Before applying CERESIT CE 33, the scraped joints must first be wetted.
In the case of tiled surfaces with a porous or non-scratch-resistant surface, test the suitability of CE 33 for grouting.

MIXING CERESIT CE 33

Pour CERESIT CE 33 into the measured amount of cold and clean water and mix with a mixer until a homogeneous mixture without lumps is obtained.
For mixing, 05-15 l of water is required for 5 kg of CERESIT CE 33. Stir again after 3 minutes.

APPLICATION OF CERESIT CE 33

Fill the joints with CERESIT CE 33 using a special putty or rubber spatula, without leaving gaps.
Wipe and clean freshly grouted tiles with a damp sponge. Remove the dry film with a soft cloth. Moisten freshly grouted joints after 24 hours,
to prevent surface moisture deficiency. The floor tiles can only be walked on after 24 hours.